PC-Deccoral® Plast

Plastering solution for aerated blocks

PC-Deccoral® Plast is a pre-mixed cementitious render designed for direct thin application onto concrete, brick, or cement block walls. This adaptable product is also compatible with aerated lightweight concrete block or panel surfaces. Application methods include manual or spray application, allowing for a thickness of up to 15 mm in one pass. It serves as a final render coat or a foundational layer for additional applications to achieve the desired thickness and surface uniformity. PC-Deccoral® Plast is suitable for both interior and exterior applications.

ADVANTAGES

  • Convenient water addition for ease of use.
  • Exceptional workability.
  • Consistent bond strength.
  • Reduced risk of cracking.
  • Cost-effective choice.

APPLICATION

Apply freshly mixed PC-Deccoral® Plast to a thickness of no more than 8-15 mm with clean steel trowel and firmly work material to attain good contact with the substrate. Allow PC-Deccoral® Plast to gain partial surface drying and return to work on the surface until the required finishing is achieved. For spray application, trim off excess material with trowel on edge immediately after spraying and return to work on final surface finishing when material attains partial surface drying. Skim coat with PC-Conrend® SC if extra smooth surface finishing is required.

DOWNLOADS

Technical Datasheet

PC-Deccoral® Plast